Robotized filament winding is a technology that involves an industrial robot placing fibres impregnated by resin along the directions of stresses the work-piece is subjected in exercise. It moves a deposition head along a winding trajectory in order to wind a tape impregnated by resin on a die. The winding tension is a very critical aspect of robotized filament winding, since it influences the compactness and the alignment of the fibres inside the composite material. The present paper underlines the problems connected to the lack of constancy of the compactness pressure during the winding of a tape on a die characterized by many different bending radii due to the complex geometry of the part to manufacture. This paper shows a study to set constant the value of the compactness pressure of the tape on the whole die. This means to assure in each point of the composite part the same value of density, percentages in volume of fibres and resin. By this study it has been possible to determine a model that is able to control in real time the tension to apply to the tape during winding or to design auxiliary devices to precompacting the tape on die, once deposited.

Requirement of compactness pressure constancy during the manufacturing of not axial-symmetric components by robotized filament winding

POLINI, Wilma
;
SORRENTINO, Luca
2006-01-01

Abstract

Robotized filament winding is a technology that involves an industrial robot placing fibres impregnated by resin along the directions of stresses the work-piece is subjected in exercise. It moves a deposition head along a winding trajectory in order to wind a tape impregnated by resin on a die. The winding tension is a very critical aspect of robotized filament winding, since it influences the compactness and the alignment of the fibres inside the composite material. The present paper underlines the problems connected to the lack of constancy of the compactness pressure during the winding of a tape on a die characterized by many different bending radii due to the complex geometry of the part to manufacture. This paper shows a study to set constant the value of the compactness pressure of the tape on the whole die. This means to assure in each point of the composite part the same value of density, percentages in volume of fibres and resin. By this study it has been possible to determine a model that is able to control in real time the tension to apply to the tape during winding or to design auxiliary devices to precompacting the tape on die, once deposited.
2006
978-079183784-9
File in questo prodotto:
Non ci sono file associati a questo prodotto.

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11580/10849
 Attenzione

Attenzione! I dati visualizzati non sono stati sottoposti a validazione da parte dell'ateneo

Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 0
social impact